Here are some stills of a video I filmed during the construction.
Unfortunately documenting was not inportant to me that time. Thatīs the reason why there are only a few photos.
Nothing works without a plan....
The wooden base before varnishing
The copper dish in a pattern, specially made for drawing
the same, with black varnish
Beyond drilling, fitted with brass nails (glued)
Smooth hands are needed.....
The chair in an early state
with fine ornamentations
A rest is putted on...
the front view
The column on the engine housing
complete with lamp cage,
bearing and connection - disk
A light - test
tiny, but delightful
The control lever
Brass - tubes for the rails, bent in fire
Ring - parts soldered (Attention, the wiring must be pulled in later)
Ornaments of brass - wire
a short comparison..
and so on..
after soldering...
polished and varnished.
The connection disk with bearing
hand painted and copied togehter
The rear podīs...
with an ornamented cone
this will be one of the console end - caps
the completed lamp - panel
lighted up...